TECHNICAL SPECIFATION FOR ASIGN BURNOUT :

Name of Equipment Assaying Burnout Electric Furnace
Maximum Operating Temperature 1100-Degree Centigrade
Heating Electrical
Temperature Control 3-½ Digit temperature controller
Thermocouple Simplex Cr/Al Type
Supply Voltage 220V-Single Phase 50Hz

DESCRIPTION OF FURNACE

GENERAL :- The furnace casing shall be manufactured from MS. Square pipe, Angle & CRC Sheet.

PAINTING :- The furnace painting will be powder coating as required by you.





Lining :-
Bottom : Hot face Insulation bricks.
Side & Back walls : Hasil block, Ceramic fiber,jipsam board backed by Graded insulation.
Door : Hot face Insulation bricks backed by graded Insulation.

HEATING ELEMENTS :- The Element will be coil type construction made from suitable dia of required SWG of kanthal wire.

ELECTRICAL :- The control panel will be consist of:

  • 1 No. Temperature controller.
  • 1 No. Air Brake Magnetic Contactor.
  • 1 No. ON/OFF Switch.
  • 4 No. Indicating Lamp.
Body Size
Single Phase
Body size : 19”W X 27”D X 18”H
Chamber Size : 8”W X 13”D X 8”H
Close type refractory
5 KW